To ensure proper spacing of your clamps, lay the horizontal bar down first and see where the notches are located. The notches (or hooks) should align with the center of the pin located on each clamp.
Secure the two clamps to your table, desk, or counter edge and tighten using the wingnut.
The vertical Upright pipes are hollow, so putting them onto the clamp pin is easy! Just slide the upright over the pin, making sure that the slots in the vertical pipe are at the top.
Slide your horizontal bar through the rod pocket on the clear vinyl drape panel.
Place the hook end (or notch) of the horizontal support rod into one of the open slots on the vertical upright pipes.
Ensure that your horizontal bar is securely in place in the slot of the vertical upright pipes. Make any final spacing adjustments with the clamps, and then ensure that your clamps are fully tightened to the table, desk, or countertop edge.
For questions regarding any portion of setting up your desktop / countertop sneeze guard kit, please contact us and we'll be happy to help guide you through it!